epeart
05-21-2004, 06:50 PM
Well Guys I'm finally installing my ASA SK1 kit , I'd like to thank CRISPVX for all his help in getting ths project started . We noticed some differences right away my blower bracket wouldn't fit over the blower. Come to find out my blower housing (pulley-side) is larger than crispvx and I'm guessing it's a newer kit because of some of the suttle differences, suchas the blower uses spacers to mount to the bracket, the fuel regulator is a bit different. My only Complaint is even for a skilled installer these instructions suck wind! the diagrams are also not the easiest things to understand I had to figure out that there had to be spacers for the blower and bracket, the diagram was showing the install of the blower to bolt right up to the bracket and when it didn't I was about to raise hell and call rennsport. I did call but couldn'tget a hold of them, thenwe found the spacers. So I'll post the progress info as it goes along, You really have to be patient when doing an install like this it says 8 to 10 hours yea right this will probably take 3 day at least to be on the safe side.
