I need a Euro spec Lighting Control Module

[thesmaz]

I'm currently living in Belgium and I am Bringing my US Spec 2002 325 xit over and I need to add a rear fog light to my car. I have Xenons, no auto matic lights on my car. If anyone has one of these switch for sale please send me a PM.

Thanks,
Steve

[Dirtboy]

I'm currently living in Belgium and I am Bringing my US Spec 2002 325 xit over and I need to add a rear fog light to my car. I have Xenons, no auto matic lights on my car. If anyone has one of these switch for sale please send me a PM.

Thanks,
Steve

You don't need the full LCM, you just need the switch panel and the rear fog light housing. The rear fog light housing is real cheap, like around 6-10 bucks. The switch panel is a bit more expensive, anywhere from $40-$180, it depends on which switch fits your car.

I put rear fogs on my US spec car and didn't have to change out the LCM. You'll also have to run wire (connected to a pin on the LCM) to the back cuz it ain't there for our models... :rolleyes:

[thesmaz]

You don't need the full LCM, you just need the switch panel and the rear fog light housing. The rear fog light housing is real cheap, like around 6-10 bucks. The switch panel is a bit more expensive, anywhere from $40-$180, it depends on which switch fits your car.

I put rear fogs on my US spec car and didn't have to change out the LCM. You'll also have to run wire (connected to a pin on the LCM) to the back cuz it ain't there for our models... :rolleyes:

Thanks for the reply :thumbup: I've alreasy got a copy of the DIY that KAZ did on bimmerworld. I was justchecking to see if someone here in Europe had one sitting around that I could get for less $$.

[Santiago]

You don't need the full LCM, you just need the switch panel and the rear fog light housing. The rear fog light housing is real cheap, like around 6-10 bucks. The switch panel is a bit more expensive, anywhere from $40-$180, it depends on which switch fits your car.

I put rear fogs on my US spec car and didn't have to change out the LCM. You'll also have to run wire (connected to a pin on the LCM) to the back cuz it ain't there for our models... :rolleyes:

Hi, you have a pic of the switch panel? I've been curious about doing this. Did you use Kaz's method from Bimmerworld?

[budman]

Go to your local dealer to pick one up..

[thesmaz]

Hi, you have a pic of the switch panel? I've been curious about doing this. Did you use Kaz's method from Bimmerworld?
In one of my searches on this board I found a parts diagram with all of the panels on it; sorry I don't have it right now. I actually haven't done it yet (cars not here) but yes I have downloaded Kaz's DIY from bimmerworld. If I find that pic again I'll post a link.

Here's the link for the thread with the pic
http://forum.e46fanatics.com/showthread.php?t=160284&highlight=rear+foglight