View Full Version : Best way to tap into OEM HU for amp?
mkppk
03-07-2005, 06:36 PM
How should I go about getting an output from the stock cd player to an amp? The amp will only be powering a set of subs.
[edit]
Oh, and what about the on/off wire so I can install switch. And while I'm asking simple questions...where should I ground in the trunk?
PLAZAMAN
03-07-2005, 07:24 PM
the stock amp is located on the left side.
Tap the Rear deck for signal (before amp)
Your gonna need a LOC if your amp doesnt accept the signal direcly
On/Off, theres a swtiched 12v wire in the harness, its white for the NON hk, dunno about HK. You can also use a meter to test.
power and ground amp.
a2theb
03-07-2005, 10:29 PM
the stock amp is located on the left side.
Tap the Rear deck for signal (before amp)
Your gonna need a LOC if your amp doesnt accept the signal direcly
On/Off, theres a swtiched 12v wire in the harness, its white for the NON hk, dunno about HK. You can also use a meter to test.
power and ground amp.
:werd: I believe it's also the same for HK systems. As for grounding the amp, you can ground it at the grounding point near the factory amp or to the grounding point near the battery. HTH
vBulletin® v3.7.2, Copyright ©2000-2010, Jelsoft Enterprises Ltd.
