DenaliXTC
09-08-2009, 05:18 PM
Ok, this was probably the first one produced by UUC. It was a prototype back when they were designing them. The tone is very very deep and its pretty loud. Its shows signs of ware as it has about 25-30k miles on it - typical bumps and bruises. The tips are the first generation tips, which are 3" but thin. Not shiny or anything. Not DTM. I'm sure any exhaust shop can cut these tips off and weld on some nice tips of your choice.
This exhaust will fit 330/325. Itll also fit 323/328 with some modification. I just had it taken off my 330ci, and the guys at my exhaust shop re-welded some of the braces, brackets, and hangers to make sure its 100% solid.
I recommend to take out the 2nd resonator with this because it sounds delicious. It could use a good cleaning but when its installed on the car you cant see any of the blemishes.
This was over 1k new. I'm asking $350 obo picked up. Located in North NJ. PM me for fastest response.
This exhaust will fit 330/325. Itll also fit 323/328 with some modification. I just had it taken off my 330ci, and the guys at my exhaust shop re-welded some of the braces, brackets, and hangers to make sure its 100% solid.
I recommend to take out the 2nd resonator with this because it sounds delicious. It could use a good cleaning but when its installed on the car you cant see any of the blemishes.
This was over 1k new. I'm asking $350 obo picked up. Located in North NJ. PM me for fastest response.
