VMRWheels

I have a 2002 330ci with sport suspension, i wanted to know if I could fit 18x9.5 et 45 VB3's with 265/35 r18 on the rear with out rubbing? and also what et you would recommend for the from wheels so it doesn't look funny?

Hi! do you buy used VMR wheels?

I had a question, I am really looking forward to buying 19 inch VB3's on my 2002 330ci. It has the sport ride height and I would like to maintain the overall size of the wheel so that my performance is not affected. What would you recommend as far as tire size goes without rubbing? I have a lot of fender space that I would like to fill without rubbing. Also, I would like the back rims to be more deep/ concave than the front rims. Thanks for the help. Looking forward to doing business with velocity motoring.

Are there any concerns I need to know about regarding the following wheel-tire set up on 2004 BMW 325i with stock suspension? I have done some research and I believe the clearance to the strut housing will be reduced by 11/16inch and outside edge of wheel will be moved out 13/16 inch. Doesn't seem like much, but I would appreciate any input.

VMR V701, 18x8.5 (all-around), 5x120, offset 45, tire size 235/40-18

thanks for the reply. Do the v10s have more concavity compare to the vb3?
as far as rubbing I do plan on lowering a bit. Not completely slammed but enough to close up the gap. will I run into problems?

I have a stock 2004 325ci an
I'm trying to put some aggressive rims on the bimmer
18in or 19in what do I need to do

sorry heres that link http://www.turnermotorsport.com/p-89...pacer-kit.aspx

Thanx for that! So without having to do the fender work, what would the narrowest tire be that i could use? The current tires i have are 225/40/18 all round.Thanx.

Hey, I have a 323Ci. Its lowered but not sure what setup it has. Would i be able to fit 18x8.5 ET35 Front and 18x9.5 ET35 Rear without having scrubbing issues? Would i need any guard rolling or anything like that? What tires would i also need to put on them please?Thanx!!

Hello, i was wondering if you have a picture refference for a Imola E46 with V701 in Matte Antracite finish. Thanks!

I can't decide between the Gunmetal or the Matte Anthracite after looking at the this thread:

http://forum.e46fanatics.com/showthread.php?t=806095

Thanks again>!