Blocked Out

Hey man,
You posted back in 2011 in a thread about the ZKW burnt bowls. You had mentioned that you could in fact buy the Al projector frames, and swap them rather easily into the ZKW housings. I am looking to fix my damn burnt up bowls and was hoping for a relatively easy fix. Can you confirm for me that they did fit, and if so what did you have to purchase, and do you have any pictures or guidelines. Also, do you have a general cost of how much it cost you? I would appreciate any help with this. There is so much information out there it is hard to get a clear answer.
Thanks again!

hay man you know a fair amount about the e46 m and non m, got a quick question.

i have a KW v2 coilover set on my 330ci and i was wondering if it would work just fine on an m3 with no modifications!

Hey man, is that imola red e46 you have there? What rims are those?

hay man hows that drive shaft holding up on the m3 diff still holding up well?

hay man i saw on a post that you are pretty familiar with a m3 lsd swap in a 330!
i need a little advice as far as the drive shaft goes? how do i get the lsd of a m3 the fit on a 5 speed?

Thanks for taking the time. That's the info I sought.
Now I would not hesitate to use the PF when I need to replace these bushings.
Sway bar bushings would be so easy to do, but I cannot imagine I'd be able to tell that difference.

hey, i got my wheels in and they dont rub. i still have to lower the car and dont think there should be any problems.

i got 19x8.5 front with 215 35 and 19x9.5 rear with 235 35 tires. The wheels are both 35 mm offset. if i went with 225 35 in front they would fit perfect but not any bigger, the rear i can go max 235 with no rubbing so im glad i chose that size.

have a look at my album, let me know what you think.

thanks for the help.

Lol fooled me man, sounds good tho.

i bet those super sprint headers sound clean, u got a vid??

quick question, you responded to my wheel fitment a few months back, bought some new wheels and was wondering about new offset fitment.

on a zhp sedan, will 19x9.5 rear with offset of 35 mm rub if its not lowered in the rear?