E46Fanatics (http://forum.e46fanatics.com/index.php)
-   General E46 Forum (http://forum.e46fanatics.com/forumdisplay.php?f=4)
-   -   ACS pedal install Question... (http://forum.e46fanatics.com/showthread.php?t=353)

PCDawg 04-12-2002 03:00 PM

ACS pedal install Question...
I've installed my ACS pedals yesterday nite :D

Man.. i installed the brake pedal first, and it was a pain in the ass but finally got them on :smile:

I did the gas pedal last and it was easy.

As i cleaned everything up and admired my work, i notice the gas pedal was a bit crooked. Its not too bad, but its off like several mm upwards. i felt stupid!!! :eeps:

I was wondering if i should removed it and re-drilled the holes, would the bolts and nuts hold the pedal just as tight since the holes would be very close to each other?? Or should I just leave it.....i have pics, but they are on my home computer.

s4play 04-12-2002 03:09 PM

Should be fine....because when you clamp
it down, the new nuts will still grab the plastic at the new point. You may want to use a very thin washer behind the nut to prevent it from pulling through the hole.

I messed mine up a bit too so I just carefully enlarged the hole in the direction I wanted the pedal to go. The screws hold fine as long as the nut doens't fall through the hole.

If you need thin washers, go to a local R/C hobby shop since they specialize and small hardware for those types of cars.


PCDawg 04-12-2002 03:27 PM


I'll just drill some holes to reshift it down a bit :)

I was just afraid that the pedal will slide up and down a bit if it wont hold still properly :D

pfloyd57 04-12-2002 05:51 PM

I usually try to warn everyone to preposition them 1st with 2 sided tape.
Then to use a center punch to start the holes. I love my ACS pedals. With the Rockport shoes I wear the grip on the pedals is much more pronounced.

I think I'm going to replace my M dead pedal with the ACS to get the full effect.

Keeferno 04-12-2002 06:02 PM

Yep, the definatly are nice. I have UUC ones and love them

Mr.Stream 04-12-2002 06:05 PM

Love mine too.

All times are GMT -5. The time now is 10:48 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
(c) 1999 - 2016 performanceIX Inc - privacy policy - terms of use