E46Fanatics

E46Fanatics (http://forum.e46fanatics.com/index.php)
-   Forced Induction Forum Sponsored by Active Autowerke (http://forum.e46fanatics.com/forumdisplay.php?f=41)
-   -   will this work (http://forum.e46fanatics.com/showthread.php?t=613747)

S54DR 10-05-2008 12:36 AM

will this work
 
will a crank out of a 95 s50 m3 work in a m52tu if so any mods to be done or will it bolt right up

_Calle_ 10-05-2008 10:03 AM

This works very well!
in Germany there are some this have made.

Variation 1 on 3.0 l (base: M50 grey iron block):
Crankshaft of the M3 3.0 US implementation. This has towards of the "normal" M3 crankshaft the advantage that the connecting rod plugs measure 45 mm (otherwise, 50 mm) and one is not bound therefore to the substantially more expensive M3 connecting rods. Moreover, KW of US-M3 is substantially more favorable.
Connecting rod 135 mm or US-M3 3.0/3.2
piston 86 mm of US-M3 3.0
The block must be drilled out on 86 mm.
ZK poetry is natural to use from US-M3 3.0/3.2 then (11 12 1 405 106) compressions corresponds to the M3 3.0 USA

copied from seite http://wp1016621.wp027.webpack.hoste...140/f01140.htm

Activ3 10-05-2008 09:28 PM

You would be going from a forged crank to a cast crank. Get the S52B32 crank, and you'll be at 3.0L


All times are GMT -5. The time now is 10:18 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
(c) 1999 - 2011 performanceIX Inc - privacy policy - terms of use