E46Fanatics

E46Fanatics (http://forum.e46fanatics.com/index.php)
-   General E46 Forum (http://forum.e46fanatics.com/forumdisplay.php?f=4)
-   -   Dynavin blowing up fuse 7 (http://forum.e46fanatics.com/showthread.php?t=805889)

jtamba 11-20-2010 08:19 PM

Dynavin blowing up fuse 7
 
I have a Dynavin unit installed last year. But last week I pulled it out to look at the connectors and put it back in right away. After that FUSE 7 has been blowing up. I've blown up 5 fuses so far by just replacing the fuse and starting my car. Anyone having this same issue? My dynavin of course is dead.

BusaNoob 11-20-2010 09:33 PM

when u pulled it out, u probably moved a bare wire around and now its making contact on the chassis, causing short and blowing fuse

jtamba 11-20-2010 10:01 PM

I'm gonna pull it out tomorrow and cover all the bare wires I can find and post the results. Thx

xi_ter 11-20-2010 10:45 PM

Or else metal on a connector is touching another connector. Good to have these connectors covered with the clear tubes supplied or else shrink wrap or tape.
There are a lot of connectors, I'd check out the clear tubes on the blue, gray and white wires.
http://img.photobucket.com/albums/v1...6/CIMG3782.jpg

DutchPlayer 09-15-2013 01:39 PM

I Know, old topic, but have kind the same problem. Today I blow up 4 fuses, and only the power wiring was connected. How did the topic starter solved the problem?


All times are GMT -5. The time now is 08:01 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
(c) 1999 - 2011 performanceIX Inc - privacy policy - terms of use