E46Fanatics (http://forum.e46fanatics.com/index.php)
-   The Tire Rack's Tire & Wheel Forum (http://forum.e46fanatics.com/forumdisplay.php?f=6)
-   -   745i wheels on E46 281i sedan (http://forum.e46fanatics.com/showthread.php?t=825435)

mychnbob 02-24-2011 12:13 PM

745i wheels on E46 281i sedan
1 Attachment(s)
Will these wheels fit on my E46 sedan? If so how. 19x9 front 19x10 in the back

C18wwn 02-24-2011 01:13 PM

what offset are they?
that makes all the difference

i've seen them on a silver coupe and they look badass, just depends what mods you draw the line at

Snik 02-24-2011 01:39 PM

I've seen pics of them on a coupe. Looks wicked.
Needs lots of stretch.
Flip em around and get offsets. 7 wheels are always aggressive on a E46.

mychnbob 02-24-2011 02:43 PM

Yea....I've seen that pick as well. "SNIKWAD" what do you mean by flip'em? I also left a msg for the offsets

Snik 02-24-2011 03:53 PM


Originally Posted by mychnbob (Post 12850010)
Yea....I've seen that pick as well. "SNIKWAD" what do you mean by flip'em? I also left a msg for the offsets

flip em around as in look on the back for the stamp... it will most likely be some 3 between 40 and 15. usually preceeded by ET or the ET will be on another spoke. iirc, OE rims its usually stamped between the bolt/stud holes.

titan510 02-24-2011 03:56 PM

the et for front and rears is et24

Snik 02-24-2011 04:06 PM

ET24 at 10" wide is gonna be a very tight fit. mega stretch and prolly fender pull and or some camber. but man it would look soooo sick.

BartenderPlease 02-25-2011 08:29 AM

Very tight fit. If you aren't slammed, have a relatively firm suspension, and have no fender lip you are good to go.


WFRFitness 02-25-2011 10:18 AM

1 Attachment(s)
Wish it was mine :excited: requires a serious stretch and a lot of fender work!

Attachment 394426

rares 02-25-2011 10:21 AM

i am really tempted to do this...

Snik 02-25-2011 10:25 AM

Get four fronts. Still needs stretched tires but minimal fender work.

Evap 02-25-2011 10:32 AM

I wanted to find a set of those so bad but couldn't find a set for less than like $3k. So jealous, OP. That'll look sick.

mychnbob 02-25-2011 10:33 AM

"I COULD DO FOUR FRONTS?" If that's the case....I'll go for it...

mychnbob 02-25-2011 10:43 AM

correction 328i.............my bad. Too excited about the wheels:excited:

VMRWheels 02-25-2011 03:23 PM

Those rears are pretty aggressive. That's about the same width and offset we recommend for M3s. It probably would be better to go with two sets of fronts and run a narrow tire to avoid having to do a whole lot of fender work.

kaotek323i 02-25-2011 04:02 PM

2 deg neg camber, aggressive fender roll and 225/35 or 235/35 in the rear and it will work. not recommended for a daily driver though.

All times are GMT -5. The time now is 02:24 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
(c) 1999 - VerticalScope Inc. All rights reserved.