E46Fanatics

E46Fanatics (http://forum.e46fanatics.com/index.php)
-   Forced Induction Forum Sponsored by Active Autowerke (http://forum.e46fanatics.com/forumdisplay.php?f=41)
-   -   Active Autowerke | E46 M3 Generation 7 Level 1 Vs Level 2 (http://forum.e46fanatics.com/showthread.php?t=964526)

Viral@ActiveAutowerke 01-08-2013 11:27 AM

Active Autowerke | E46 M3 Generation 7 Level 1 Vs Level 2
 
Active Autowerke E46 M3 Generation 7 Supercharger Kits



Race on Sunday, to sell on Monday. This old saying is indicative of the new Generation 7 supercharger system for the E46 M3. Through countless hours of testing, it has often been quoted that the true test has always been a race environment. What better venue than Brock Yates One Lap of America Race. With a rigorous 7,000 miles to be covered within a week, and to compete against the likes of Porsches, Corvettes, Nissan GTRs, this would be the testing grounds for the new Generation Active Autowerke Supercharger system. The Active Autowerke Generation 7 Supercharger System not only proved its worth by being the highest ranked BMW within the field, but also ranked 1st in its class.

The data and technology that made this winning combination is now being applied in the new Generation 7 of the Active Autowerke supercharged E46 M3 Level 2. Reliability and power are needed if you want to be on the podium, and this new Generation 7 will deliver exactly that. Consistent, repeatable runs of over 420 WHP (510 engine horsepower) were recorded from our Level 1 kit on the Active Autowerke Mustang chassis dyno in hot 94 + degree Fahrenheit conditions with humidity in the 60% + range.

The stage 2 System boosts the S54's power output to over 600BHP and includes an upgraded fuel system (includes two fuel pumps, fuel filter, all new -6 lines, fuel pressure regulator, dead end fuel rail, upgraded injectors and all required fittings). This ugpraded fuel system is a must once reaching these increased boost levels due to the fact that the factory fuel system is simply inadequate at this level. The stage 2 system also use a larger front mount air to air intercooler and our custom methanol injection system.


secono330ci 01-08-2013 11:32 AM

Wow very nice Viral!

bobm3 01-09-2013 12:08 PM

nice going v
 
good to see you guys are uping the rhp numbers...and nice to see you are still trying to get more rhp for our e46 m3's cars...
bob :bow::bow:

AMG-ETR 01-10-2013 04:14 PM

Hey Viral,

On the old generation 6 Stage II dyno it was 519 rwhp and 370 rwtq - I thought with the generation 7 manifold it would be higher than the previous dyno. This reads 510 rwhp and 360 rwtq.

I was hoping to at least break 550 rwhp and 380 rwtq considering I made 440 rwhp and 316 rwtq with your Gen 6 stage 1.5:


LilFlip#2 01-10-2013 08:59 PM

viral

I need a discount for stage 2...PM the price

its Bashar

You need to harass me

Viral@ActiveAutowerke 01-11-2013 08:37 AM

Quote:

Originally Posted by secono330ci (Post 15041464)
Wow very nice Viral!

Thank you for the kind words brotha :craig:

Quote:

Originally Posted by bobm3 (Post 15044888)
good to see you guys are uping the rhp numbers...and nice to see you are still trying to get more rhp for our e46 m3's cars...
bob :bow::bow:

Thanks Bob your M3 makes some great power as well. :woot::woot::woot:


Quote:

Originally Posted by A55A55IN (Post 15049299)
Hey Viral,

On the old generation 6 Stage II dyno it was 519 rwhp and 370 rwtq - I thought with the generation 7 manifold it would be higher than the previous dyno. This reads 510 rwhp and 360 rwtq.

I was hoping to at least break 550 rwhp and 380 rwtq considering I made 440 rwhp and 316 rwtq with your Gen 6 stage 1.5:


The New Gen 7 Manifold made more power in the 1 & 1.5 Kit to allow for a much more efficient Air Flow and stronger design than our previous Generation "Box Style Manifold". The Peak power can vary from vehicle to vehicle since no 2 cars can make identical power due to conditions on the vehicle mileage, condition can vary.

Quote:

Originally Posted by LilFlip#2 (Post 15050237)
viral

I need a discount for stage 2...PM the price

its Bashar

You need to harass me

:shhh: Check your Inbox :craig:

Don't worry I will send you a Miami Heat Tag with your Stage 2 Upgrade :evil:

AAblown 01-11-2013 06:00 PM

:bow: SO GOOD

nek0 01-11-2013 10:45 PM

Yeah I was looking into buying the gen 7 manifold but after seeing my car makes the same power with the gen6 manifold I guess I'll just be saving my money and going pro efi

LilFlip#2 01-13-2013 10:47 PM

I did not get your pm

Irishace 01-14-2013 07:09 AM

@Viral@activeautowerke, couple quiestions:

1. Do you provide the Rotrex blower option for this kit? You mentioned you have some customers use it so I was curious if you it could be requested as part of the Stage II kit? Also, any dynos of the Rotrex option?

2. These graphs on pump gas + meth?

3. I am still learning the S54, but will the DME adjust and add timing if you are running race gas? Curious to know what the power numbers might look like on race + meth.

Great looking product, appreciate answers to my questions.

Viral@ActiveAutowerke 01-14-2013 03:47 PM

Quote:

Originally Posted by AAblown (Post 15053083)
:bow: SO GOOD

Thank you Sir :craig: Can't wait to see the E30 M3 Project :drool:

Quote:

Originally Posted by LilFlip#2 (Post 15058244)
I did not get your pm

Check your inbox again :read:...... :woot: You can give me a E-Hug later :craig:

Quote:

Originally Posted by Irishace (Post 15058925)
@Viral@activeautowerke, couple quiestions:

1. Do you provide the Rotrex blower option for this kit? You mentioned you have some customers use it so I was curious if you it could be requested as part of the Stage II kit? Also, any dynos of the Rotrex option?

We did 2 Rotrex Systems as custom projects for customers. We have the ability to build these kits since we have the new Rotrex C38-92 Trim Blowers available. I will post the Dyno's once I get charts from our Engineering Department.

2. These graphs on pump gas + meth?

Majority of our Dyno's we post use 93 Octane for Pump Gas and we use Methanol as a cooling additive to prevent engine knock from high temps due to heat. The Stage 2 System come with and require Methanol to achieve the Advertised Horsepower Numbers.

3. I am still learning the S54, but will the DME adjust and add timing if you are running race gas? Curious to know what the power numbers might look like on race + meth.

We have the ability to tune to run with High Octane w/ race fuel but the DME would need to be flashed with the Software to adjust for timing. We offer a Simon Hand held device which allows you to load and change maps through flashing through the OBD2 Port. The S54 + Boost + Race Fuel & Meth = Lots of fun :drool:

Great looking product, appreciate answers to my questions.

Hopefully this helps please feel free to contact me directly via E-mail or by Phone on the number below and I will be more than glad to help answer any of your questions. :hi:

LilFlip#2 01-14-2013 08:30 PM

Just pulled the plug and ordered the stage 2 from AA. I will update you guys as soon as I install. Once again thanks to Viral for taking my hard earned money





430 rwhp is getting pretty boring

Brandon@activeautowerke 01-14-2013 09:38 PM

Quote:

Originally Posted by LilFlip#2 (Post 15061482)
Just pulled the plug and ordered the stage 2 from AA. I will update you guys as soon as I install. Once again thanks to Viral for taking my hard earned money





430 rwhp is getting pretty boring

:woot:

Irishace 01-15-2013 07:06 PM

Quote:

Originally Posted by Viral@ActiveAutowerke (Post 15060639)
Thank you Sir :craig: Can't wait to see the E30 M3 Project :drool:



Check your inbox again :read:...... :woot: You can give me a E-Hug later :craig:



Hopefully this helps please feel free to contact me directly via E-mail or by Phone on the number below and I will be more than glad to help answer any of your questions. :hi:

Thanks appreciate the answers

m3816 01-15-2013 09:31 PM

Quote:

Originally Posted by LilFlip#2 (Post 15061482)
Just pulled the plug and ordered the stage 2 from AA. I will update you guys as soon as I install. Once again thanks to Viral for taking my hard earned money





430 rwhp is getting pretty boring

Congrats you will love it :) make sure he sends you the Heat license plate bracket too!

AMG-ETR 01-15-2013 10:45 PM

Hey how come I didn't get a Heat plate frame :(

FragNasty 01-16-2013 05:25 AM

Quote:

Originally Posted by Viral@ActiveAutowerke (Post 15041438)

I have a few quick questions:

From 7.3k to 8k the torque curve seems to dip a bit do you know why? Could it be that the compressor is falling out of it's efficiency island or is a cam related issue?

I noticed the gen 6 stg II kit starts that characteristic dip at about 6.7k it seems that the gen 7 tune has managed to keep torque numbers up until later. Is that a result of a vanos tune/tweek or is it related to an upgraded compressor?

Is the gen 6 stg II is running something like 9 or 10 psi? The torque numbers are a bit higher than the gen7 stg I (8 psi).


All times are GMT -5. The time now is 08:14 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
(c) 1999 - 2011 performanceIX Inc - privacy policy - terms of use