E46Fanatics

E46Fanatics (http://forum.e46fanatics.com/index.php)
-   General E46 Forum (http://forum.e46fanatics.com/forumdisplay.php?f=4)
-   -   Video: how to bleed your E46 non-m cooling system (http://forum.e46fanatics.com/showthread.php?t=969478)

Mango 02-05-2013 02:36 AM

Video: how to bleed your E46 non-m cooling system
 
I'll add this to the cooling thread (if it lets me. if not, i'll have to ask jake to add it) but I'll also put this in a new thread to increase the chance someone finds it. Hopefully it can give a visual aid in what to do. I put this together at midnight so sorry for any typos or inconsistencies.

http://youtu.be/mX2EFnAL-Q8

Summary:

Step 1) Raise front of vehicle on ramps or incline. This helps the air bubbles escape easier.

Step 2) Insert key, turn to the ON position (dash lights on--engine OFF)

Step 3) Turn heater to MAX heat and fan speed to LOW.

Step 4) Completely remove bleed screw and expansion tank cap. Set aside.

Step 5) Pour your desired mixture of Genuine BMW coolant and distilled water into the expansion tank. Approximately two gallons will be used to satisfy an empty system.

Step 6) Once the system is starting to fill to capacity, water and air bubbles will escape the bleed hole. Have a bucket to catch the spilling coolant. Keep pouring water or coolant (in my case, I pour distilled water only) until water comes out of the bleed hole without any bubbles. It should be a steady stream of water. Do this for about 2-3 minutes or until you are satisfied there are no more bubbles.

Step 7) Siphon off any excess water before reinstalling the bleed screw and expansion tank cap and eventually starting the engine.

Step 8) Monitor engine temps using the OBC method (Google it if you don't know how). Temps should read between 87 and 98c once the car has warmed up and driven. You might need to bleed again or top off coolant the next day.

Step 9) Keep monitoring for the next few days so the system stablizes.

Step 10) Visit E46Fanatics.com and check into my cooling thread if you liked this video or information. Let me know!

http://forum.e46fanatics.com/showthread.php?t=914109

Vandyinc 02-08-2013 03:54 AM

Thanks Mango, Good Video. :thumbsup: Was it a coincidence or do you color coordinate your funnels with the fluids you pour through them? :hmm:

Goondaddy 02-08-2013 05:03 AM

First off, thanks for doing this. You'll be surprised how much it helps visually inclined people.

On a side note: It's hard to read text when it's on a picture or video.

Mango 02-08-2013 10:12 AM

Quote:

Originally Posted by Vandyinc (Post 15142232)
Thanks Mango, Good Video. :thumbsup: Was it a coincidence or do you color coordinate your funnels with the fluids you pour through them? :hmm:


coincidence but good idea

Quote:

Originally Posted by Goondaddy (Post 15142281)
First off, thanks for doing this. You'll be surprised how much it helps visually inclined people.

On a side note: It's hard to read text when it's on a picture or video.

I agree... that's why there's my guide so you have both :lmao: I also put the instructions in the youtube comments.

matchee 02-08-2013 10:14 AM

Thanks I used your message in the other thread...


All times are GMT -5. The time now is 08:46 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
(c) 1999 - 2011 performanceIX Inc - privacy policy - terms of use