E46Fanatics

E46Fanatics (http://forum.e46fanatics.com/index.php)
-   Forced Induction Forum Sponsored by Active Autowerke (http://forum.e46fanatics.com/forumdisplay.php?f=41)
-   -   Force Induction cams (http://forum.e46fanatics.com/showthread.php?t=972947)

spykes 02-24-2013 11:06 PM

Force Induction cams
 
So this week I'm tackling a Cam install using the FAQ from jared_wiesner and G.A.S tool. I was wondering after installing these supercharge cams 248/268 can I drive the car without having the supercharge installed yet. It's my daily driver. I'm already tired of my mom's CR-V ha

TrippinBimmer 02-24-2013 11:41 PM

serious?

spykes 02-24-2013 11:42 PM

The only other thing is to beach the car and have the setup fully installed before I drive it, but I'm hoping It would run with those supercharge cams alone for now.

SweTurbo 02-25-2013 06:38 AM

It will run no worries :)

jared_wiesner 02-25-2013 09:58 AM

Should run, may have less power than normal.

Ky///m3 02-25-2013 01:51 PM

this is going to be good

spykes 02-25-2013 02:10 PM

People are scaring me maybe I shouldn't drive it lol

Think0rz 02-25-2013 03:17 PM

no reason to be scared at all as long as your valve train is meant to deal with your new cams you will be fine. As some of the others have mentioned you might lose some power being NA as the cams were designed for an FI engine. None the less drive your car until you can install/purchase your supercharger

Dirtboy 02-25-2013 09:52 PM

It'll run. I had my FI cams installed before I installed my supercharger and ran the car. Granted, I only drove it from the shop that did the cam install to my shop where I installed the supercharger, about 10 miles. But it'll run.

spykes 02-25-2013 11:05 PM

Sounds good because Right now Im still preparing everything for the charger install. The cams are in but I haven't timed them yet.

spykes 03-03-2013 04:43 PM

i just finish the install today. everything looked like the pictures and I started up the
car. I had no problems though ide was a bit rough it was smooth and consistent. after 3 mins of idle the car began to shake.
Is it a tuning issue? i don't see any black smoke or any issues until it finish warming up and the RPM drops. I'm hoping this is a software issue at this moment.

Commanderwiggin 03-03-2013 05:00 PM

Just go do some WOT pulls to learn the ECU...should find out pretty quick how the install went.

TrippinBimmer 03-03-2013 07:31 PM

Quote:

Originally Posted by Commanderwiggin (Post 15214557)
Just go do some WOT pulls to learn the ECU...should find out pretty quick how the install went.

Restart and does cel come on? If it does cam are not timed correctly.

Maximkabrovary 08-23-2013 06:24 PM

anybody has a catalogue number of this cams? 264/248 wanna buy schrick, but not shure what else parameters to choose?


All times are GMT -5. The time now is 08:30 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
(c) 1999 - 2011 performanceIX Inc - privacy policy - terms of use