E46 BMW Social Directory E46 FAQ 3-Series Discussion Forums BMW Photo Gallery BMW 3-Series Technical Information E46 Fanatics - The Ultimate BMW Resource BMW Vendors General E46 Forum The Tire Rack's Tire Wheel Forum Forced Induction Forum The Off-Topic The E46 BMW Showroom For Sale, For Trade or Wanting to Buy

Welcome to the E46Fanatics forums. E46Fanatics is the premiere website for BMW 3 series owners around the world with interactive forums, a geographical enthusiast directory, photo galleries, and technical information for BMW enthusiasts.

You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

If you have any problems with the registration process or your account login, please contact contact us.


Go Back   E46Fanatics > Search Forums

You searched for the keyword(s):
Your search results are listed below. If you did not find the answer you were looking for, please try searching again. Make sure that you are searching the entire site and not a specific forum. If you cannot find the answer to your question, create a new discussion topic in the appropriate BMW related or Off-Topic section.

Showing results 1 to 25 of 220
Search took 0.81 seconds.
Search: Keyword(s): ; Posts Made By: 4dr05zhp6mt
Forum: Driveline, Engine & DME Tuning 08-26-2011, 03:14 AM
Replies: 111
Views: 40,209
Posted By 4dr05zhp6mt
QUOTE] ...

QUOTE]
:100000006335363636353038343330303636303185
:1000100031313134333030303636303130303030C9
:1000200031313134333030303636303130303030B9
:1000300031313134333030303636303130303030A9...
Forum: Driveline, Engine & DME Tuning 08-22-2011, 01:30 PM
Replies: 111
Views: 40,209
Posted By 4dr05zhp6mt
Reading the EEPROM is a little different than...

Reading the EEPROM is a little different than software functionality. In order to have read access to the EEPROM the cpu is usually forced into a configuration mode. This is accomplished via hardware...
Forum: Driveline, Engine & DME Tuning 08-19-2011, 11:53 AM
Replies: 111
Views: 40,209
Posted By 4dr05zhp6mt
Google Vag KKL cable. If the EEPROM is grayed out...

Google Vag KKL cable. If the EEPROM is grayed out as you put it, first thought that comes to mind is the hardware is not setup correctly.
Forum: Driveline, Engine & DME Tuning 08-11-2011, 05:10 PM
Replies: 5
Views: 1,352
Posted By 4dr05zhp6mt
Sorry if its a repost, but a good article on...

Sorry if its a repost, but a good article on nevertheless .
http://www.dinancars.com/university/
Forum: Forced Induction Forum Sponsored by Active Autowerke 08-10-2011, 12:55 PM
Replies: 35
Views: 4,749
Posted By 4dr05zhp6mt
My similiar high pitched screech stopped after...

My similiar high pitched screech stopped after replacing the ebay headers.
Forum: General E46 Forum 08-10-2011, 12:03 PM
Replies: 1
Views: 495
Posted By 4dr05zhp6mt
check your precat O2's.

check your precat O2's.
Forum: Forced Induction Forum Sponsored by Active Autowerke 08-02-2011, 04:35 PM
Replies: 55
Views: 5,912
Posted By 4dr05zhp6mt
+1

+1
Forum: Great Lakes 07-09-2011, 06:00 PM
Replies: 0
Views: 483
Posted By 4dr05zhp6mt
vac cam install tool...help

Any body in Chicago area have a cam alignment tool. For M54/52 VAC/Shrick cam?
Forum: Forced Induction Forum Sponsored by Active Autowerke 07-07-2011, 01:49 PM
Replies: 10
Views: 1,807
Posted By 4dr05zhp6mt
I've been seeing about 75-90 miles/tank at...

I've been seeing about 75-90 miles/tank at similar speed.
Forum: Forced Induction Forum Sponsored by Active Autowerke 07-07-2011, 01:43 PM
Replies: 42
Views: 7,619
Posted By 4dr05zhp6mt
Congrats. Enjoy.

Congrats. Enjoy.
Forum: Forced Induction Forum Sponsored by Active Autowerke 07-01-2011, 11:07 PM
Replies: 4
Views: 617
Posted By 4dr05zhp6mt
I have a dyno from the 85mm, headers and 248/248...

I have a dyno from the 85mm, headers and 248/248 setup which is archived in a thread here. The numbers I believe the #'s were (342/297). But, nothing with the 80mm or with the new cams yet. I can...
Forum: Forced Induction Forum Sponsored by Active Autowerke 07-01-2011, 09:37 PM
Replies: 4
Views: 617
Posted By 4dr05zhp6mt
Comp #'s: 25k Miles after going AA Stage 2.

After learning of a couple zhp's experiencing a loss of compression with the stage2 85mm pulley I asked Fluid Motor Union to perform a compression test while they had the my car to install a set of...
Forum: Forced Induction Forum Sponsored by Active Autowerke 04-10-2011, 03:32 PM
Replies: 0
Views: 373
Posted By 4dr05zhp6mt
What to make of my Air/Fuel

I've been trying to make some sense of this plot and to me it seems the numbers would indicate the mixture is rich. The data after the 150 mark looks smoother, however this data was collected as the...
Forum: Driveline, Engine & DME Tuning 01-09-2011, 04:15 PM
Replies: 1
Views: 1,158
Posted By 4dr05zhp6mt
Helpful Siemens C167CR

SAB80Cf167CR processor - MS43 DME

Document's should give a basis for the hardware and architecture.

I don't know which Flash chip Siemen's uses but I wouldn't be concerned with the...
Forum: Driveline, Engine & DME Tuning 01-07-2011, 01:56 PM
Replies: 5
Views: 1,473
Posted By 4dr05zhp6mt
The AA software build I am using does prevent...

The AA software build I am using does prevent CEL's stemming from the Secondary 02 sensors, I don't even have secondaries plugged in.

Do you have 1 secondary 02 with a sim and 1 secondary 02...
Forum: Forced Induction Forum Sponsored by Active Autowerke 12-15-2010, 05:41 PM
Replies: 12
Views: 1,362
Posted By 4dr05zhp6mt
The plateau and falll in boost at the end was...

The plateau and falll in boost at the end was caused by the tech lifting near redline. Should have seen ~ 1psi(maybe 15 more hp) if he stayed in it to 7k. The quick rise, I'm not sure, maybe do to...
Forum: Forced Induction Forum Sponsored by Active Autowerke 12-15-2010, 04:08 PM
Replies: 12
Views: 1,362
Posted By 4dr05zhp6mt
Check out the bottom of the dyno plot which shows...

Check out the bottom of the dyno plot which shows how much boost an AA Stage 2 is making. I wouldn't think twice about running a smaller pulley for around 12~14 psi.
Don't know what AA would charge...
Forum: General E46 Forum 12-09-2010, 02:28 PM
Replies: 54
Views: 3,526
Posted By 4dr05zhp6mt
I would have hoped to see a tab around $800. If...

I would have hoped to see a tab around $800. If you're happy with the repair work, a couple hundred dollar premium shouldn't bother much.
Forum: Forced Induction Forum Sponsored by Active Autowerke 12-09-2010, 12:32 PM
Replies: 86
Views: 8,530
Posted By 4dr05zhp6mt
My experience with the AA kit has been positive. ...

My experience with the AA kit has been positive. I use it as my daily driver. It has shown to be reliable from the recent negative single digit temps in chicago to the triple digit temps in...
Forum: Driveline, Engine & DME Tuning 12-05-2010, 02:58 PM
Replies: 49
Views: 5,848
Posted By 4dr05zhp6mt
Did you still have the sim hardware in loop when...

Did you still have the sim hardware in loop when you tried the reset?
Forum: Driveline, Engine & DME Tuning 12-04-2010, 04:51 PM
Replies: 49
Views: 5,848
Posted By 4dr05zhp6mt
From what I understand after you clear error...

From what I understand after you clear error codes you need to perform the following drive cycle which will trigger the monitors to reset. Here is a link below....
Forum: General E46 Forum 12-02-2010, 03:02 PM
Replies: 9
Views: 732
Posted By 4dr05zhp6mt
What's a AA stage 2 zhp market value?

Just looking to solicate some feedback on vehicle value. I have the itch for a new vehicle again.

05 330i zhp 6speed
88K
AA stage 2 with meth/water injection.
Good Condition - Dealer...
Forum: Complete Cars 12-02-2010, 02:54 PM
Replies: 4
Views: 821
Posted By 4dr05zhp6mt
Quick numbers 17 x 439 + 500 is about $7900 for...

Quick numbers 17 x 439 + 500 is about $7900 for 10k miles. So it's about 79 cents/mile to drive. Is there a fee at turn in also?
Forum: Forced Induction Forum Sponsored by Active Autowerke 11-25-2010, 12:41 PM
Replies: 35
Views: 4,749
Posted By 4dr05zhp6mt
I have always thought it was the S/C belt making...

I have always thought it was the S/C belt making noise dyno shows even with the sound no drop in boost or horsepower, Im 99% sure not a boost leak or bad bypass valve. It is an interesting fact ...
Forum: Forced Induction Forum Sponsored by Active Autowerke 11-25-2010, 12:30 PM
Replies: 35
Views: 4,749
Posted By 4dr05zhp6mt
Please let me know, that is the sound I've been...

Please let me know, that is the sound I've been trying to fix for months with my car. I also have headers and a magnaflow catback.......
Showing results 1 to 25 of 220


 

All times are GMT -5. The time now is 09:09 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
(c) 1999 - 2011 performanceIX Inc - privacy policy - terms of use