E46 BMW Social Directory E46 FAQ 3-Series Discussion Forums BMW Photo Gallery BMW 3-Series Technical Information E46 Fanatics - The Ultimate BMW Resource BMW Vendors General E46 Forum The Tire Rack's Tire Wheel Forum Forced Induction Forum The Off-Topic The E46 BMW Showroom For Sale, For Trade or Wanting to Buy

Welcome to the E46Fanatics forums. E46Fanatics is the premiere website for BMW 3 series owners around the world with interactive forums, a geographical enthusiast directory, photo galleries, and technical information for BMW enthusiasts.

You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

If you have any problems with the registration process or your account login, please contact contact us.


Go Back   E46Fanatics > Search Forums

You searched for the keyword(s):
Your search results are listed below. If you did not find the answer you were looking for, please try searching again. Make sure that you are searching the entire site and not a specific forum. If you cannot find the answer to your question, create a new discussion topic in the appropriate BMW related or Off-Topic section.

Showing results 1 to 25 of 34
Search took 0.43 seconds.
Search: Keyword(s): ; Posts Made By: felixzcat
Forum: General E46 Forum 05-22-2014, 12:51 PM
Replies: 10
Views: 349
Posted By felixzcat
You may not be able to feel strut/lower ball...

You may not be able to feel strut/lower ball joint play by hand as struts are spring loaded even with car off ground unlike the tie rods which are not loaded.
Forum: General E46 Forum 02-07-2014, 03:01 PM
Replies: 9
Views: 485
Posted By felixzcat
Ha may have to run 2 degrees negative camber to...

Ha may have to run 2 degrees negative camber to get the 8.5 M3 wheels within the wheel well/fender lip. I have the same setup on my lowered 2001 wagon.

That said, I get 35k from the Michelin...
Forum: General E46 Forum 12-29-2012, 03:04 PM
Replies: 4
Views: 471
Posted By felixzcat
I use my little black plastic one when I go...

I use my little black plastic one when I go hiking or running. So to actually operate the car, the material doesnt seem to matter.

Paul
Forum: General E46 Forum 06-17-2011, 05:28 PM
Replies: 29
Views: 4,092
Posted By felixzcat
Threetwentyfizzle, Just to be sure before I...

Threetwentyfizzle,

Just to be sure before I do mine, you are talking about the right side of the tank, correct? And resetting the instrument cluster had nothing to do with the fuel gage reading...
Forum: General E46 Forum 09-22-2010, 02:41 PM
Replies: 15
Views: 1,377
Posted By felixzcat
1st cupholder is for cup, second cupholder is for...

1st cupholder is for cup, second cupholder is for sunglasses and or cell phone :)
Forum: Parting Out 09-22-2010, 09:50 AM
Replies: 4
Views: 862
Posted By felixzcat
I have part #1 I now need part #10,11 and...

I have part #1

I now need part #10,11 and 12.

If anyone wants to sell these without the main airbox/filter assembly, let me know.

Paul
Forum: Parting Out 08-10-2010, 11:57 AM
Replies: 4
Views: 862
Posted By felixzcat
bump

bump
Forum: Parting Out 08-09-2010, 02:53 PM
Replies: 225
Views: 25,425
Posted By felixzcat
Airbox assembly? See my WTB posed today

Airbox assembly? See my WTB posed today
Forum: Parting Out 08-09-2010, 02:43 PM
Replies: 4
Views: 862
Posted By felixzcat
WTB Air box and inlet (stock) E46 325 m54

In need of complete assembly is nice to excellent condition. I really need 1, 10, 11 and 12 in the diagram as complete original assemblies.

I am located in Orange County California 92630

Let...
Forum: General E46 Forum 11-30-2009, 10:29 AM
Replies: 18
Views: 2,083
Posted By felixzcat
A serious pain in the ass. I've blown two...

A serious pain in the ass. I've blown two expansion tanks by overfilling. My third tank is on order :)

BTW, your coolent fill methode is incomplete. One needs to have ignition key on second...
Forum: General E46 Forum 11-28-2009, 12:50 PM
Replies: 18
Views: 2,083
Posted By felixzcat
Can you explane how you know this to be true? ...

Can you explane how you know this to be true?

I have read many stories of broken tanks, this is the first time I have read that it can be caused by overfilling.

Is there no releif valve in...
Forum: General E46 Forum 10-30-2009, 03:00 PM
Replies: 15
Views: 3,235
Posted By felixzcat
I would like to add one thing for future coolant...

I would like to add one thing for future coolant bleeders.

The "Bleed Screw" is a crappy plastic screw with a hole drilled through it right at the most stressed part of the screw. Be carefull when...
Forum: General E46 Forum 04-27-2009, 12:47 PM
Replies: 45
Views: 33,707
Posted By felixzcat
The harness is $300. First time DIY is said to be...

The harness is $300. First time DIY is said to be 6-7 hours :omg:

I believe the engine harness was a recall item up to 2002.

Cheers,
Paul
Forum: General E46 Forum 04-27-2009, 10:01 AM
Replies: 45
Views: 33,707
Posted By felixzcat
If you have the ability to read the codes then I...

If you have the ability to read the codes then I would try swapping coils around to double check if the new code confirm a bad coil. My research on this forum indicates the harness and DISA valve are...
Forum: DIY: Do It Yourself 04-23-2009, 02:57 PM
Replies: 35
Views: 8,101
Posted By felixzcat
Thanks for the update Luky. "I get a table...

Thanks for the update Luky.

"I get a table 19 F5/F6 which is the Precat 02 sensor preheaters or something."

My table 19 says that F5/F6 is -Secondary air system too low- cyl 1-3/4-6.
...
Forum: DIY: Do It Yourself 04-01-2009, 06:20 PM
Replies: 35
Views: 8,101
Posted By felixzcat
I actually PM'd Luky for an update caus I've got...

I actually PM'd Luky for an update caus I've got very similar codes. Hopefully he'll chime in here. I'm getting 9 codes including all that Luky had, yet the car drives fine, and every once in a while...
Forum: General E46 Forum 03-28-2009, 12:39 PM
Replies: 22
Views: 1,231
Posted By felixzcat
Buckrogers, Sounds like you've had the...

Buckrogers,

Sounds like you've had the header tank off? Is the top of the tank locked on to the radiator? If you can move the top of the tank around, it's not locked on, and the tab on the front...
Forum: General E46 Forum 03-18-2009, 03:16 PM
Replies: 45
Views: 33,707
Posted By felixzcat
I'm may be suffering through this as we speak. ...

I'm may be suffering through this as we speak.

My research is indicating that the engine harness and Throttle Position Sensor are very suspect on the early E46. Apearently the harnesses are known...
Forum: General E46 Forum 03-17-2009, 06:47 PM
Replies: 11
Views: 766
Posted By felixzcat
This crap scares me and I'm goin through it right...

This crap scares me and I'm goin through it right now.

Car runs fine but, tripped 6 codes last Sunday including Throttle PS. Best guess is the Harness due to bad crimping on the terminal ends...
Forum: General E46 Forum 03-17-2009, 02:57 PM
Replies: 5
Views: 700
Posted By felixzcat
See, this is what I hate about electronics and...

See, this is what I hate about electronics and cars. My "service engine soon" light went out while I was driving today. All those codes dissapeared? So now I dont have any car problems?

I think...
Forum: General E46 Forum 03-17-2009, 11:14 AM
Replies: 4
Views: 1,381
Posted By felixzcat
That is a good point. I was going to start with a...

That is a good point. I was going to start with a new harness :) and cross my fingers. When I get the car apart, I'll check the mfg. date. Do you think I'll be able to see it without removing the...
Forum: General E46 Forum 03-16-2009, 06:51 PM
Replies: 4
Views: 1,381
Posted By felixzcat
Seth, My car was built 1-2001. Would...

Seth,

My car was built 1-2001.

Would this be the part?

Throttle Housing Assy 13547502444 $264.49
Forum: General E46 Forum 03-16-2009, 04:53 PM
Replies: 4
Views: 1,381
Posted By felixzcat
position sensor 1-where are you?

Code 76 came up for my 2001 325 wagon.

Anyone know where throttle position sensor 1 is located?

Is it built into the throttle assembly or is it a seperate sensor that I can buy?

Thanks in...
Forum: General E46 Forum 03-16-2009, 03:00 PM
Replies: 5
Views: 700
Posted By felixzcat
After five days, these codes came up this...

After five days, these codes came up this morning:

19 table

76 throttle pos sensor 1, plausability,range or performance
e4 o2 sensor adaption limit 4-6
e3 o2 sensor adaption limit 1-3
a8...
Forum: Interior 03-16-2009, 10:56 AM
Replies: 28
Views: 2,714
Posted By felixzcat
Interested in black front door panels if they fit...

Interested in black front door panels if they fit a 2001 325 wagon.

Sorry, I'm a BMW nubee.

Paul
Showing results 1 to 25 of 34


 

All times are GMT -5. The time now is 11:43 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
(c) 1999 - 2011 performanceIX Inc - privacy policy - terms of use