View Single Post
Old 02-26-2010, 06:45 PM   #82
mass03m3
Registered User
 
Join Date: Mar 2008
Location: Massachusetts
Posts: 150
My Ride: e46 M3
Quote:
Originally Posted by jeffb325 View Post

Basically to install this it needs to be spliced in line into the dynavin wire harness on the speaker outputs.
Jeff,
I just read the directions online for the pac oem2.. I have 2 questions.

1. Do I need power hooked to the pac oem2? Directions basically say that
these wires(constant power,switched power etc) go directly through from input to output for convenience of wiring. I figured I would just run it by you.

2. On Dynavin's website they claim "45 watts X 4 power output. On The pac oem2 instructions they list 2 different positive speaker wires(for LF,Rf,RR,LR) on the input and output of the unit.
For Example: They say to use the white(Lf +) speaker wire if your aftermarket radio has a high power speaker output of 20w X 4 and higher or if your aftermarket radio has a low speaker output of 20w x 4 or lower use the white/red(LF+).
I imagine I would be using the white wire for the left front as Dynavin claims 45W X 4 Correct?
thanks
__________________
mass03m3 is offline   Reply With Quote