View Single Post
Old 03-23-2010, 03:14 PM   #48
boyguan
Registered User
 
Join Date: Apr 2007
Location: san francisco
Posts: 122
My Ride: 02 330i
i had some trouble getting the new hub on as i needed to tap it in. i was worried that i was going to marr the spindle. what i did was i took the 46mm socket and tapped it on as sit was just right to seat against the bearing and the inner part of the hub. worked great.

my inner race came off with a few spins and did not need a puller or to dremel it. the trick for leaving the rotor on and tapping it with a mallet really works as i think that is what cause the hub to come off so easily. i finished this in about 1.5 hours from pull in to cleaned up and on the road.
boyguan is offline   Reply With Quote