Here is a pic of the install tool, it's the threaded rod I mentioned cut down to 180mm with a 3/8" socket welded to the end of it. I was thinking of using the factory washer with a thrust bearing and a M18X1.5 nut to run it down.
In hind sight the threaded rod might be too short use a box-end wrench, but you can't go any longer or you run into the radiator. I might need to remove the A/C pulley to use a box-end wrench.
Now the fun part will be making a removal tool.
Last edited by F1004fun; 05-08-2010 at 02:09 PM.