View Single Post
Old 08-28-2010, 10:39 PM   #22
Is NOT A Mechanic
ken@bimmertools's Avatar
Join Date: Oct 2006
Location: NJ
Posts: 3,560
My Ride: F30
Setting up the angles:

What I like to do is put a scrap of crown in the saw and hold it at the correct angle. I then clamp/setup on a stop parallel with the saw's fence. This allows you to just drop the crown into place and cut, only worrying about the angle.

Cutting outside corners is easy, inside requires the coping discussed above.

Bimmertools is under new ownership! Please welcome
Click Here to say hi.
ken@bimmertools is offline   Reply With Quote