Part 3 - Door speakers, tweeter mounts
Pieces for the doors. I am using a hybrid design that is hopefully going to work out well. I like the idea of door mounting, but don't like where the woofer sits (back too far and many times not "aimed" correctly). I like the idea of door panel mounting, but there isn't enough solidity there. So here is my hybrid solution...close to the grill, angled correctly, and solid. Hope it fits, I actually haven't even checked it yet...I have faith!
Marked my door cut locations. I used a Dremel tool with the new super-cut-off wheels. I went through about 4 per door. Lots of hot sparks so I protected the car with a tarp. I cut on either side of the window "track", instead of trying to cut across it without hurting it. Coated my cut edges with silicone for rust prevention.
Tweeter templates (traced the OEM ones). Hole sawed them. Mounted tweeters to templates, then to the doors. Easy stuff!
That's all till next time. Probably a few day till completed if I don't hit any snags!
Last edited by radarcontact; 10-18-2010 at 08:09 PM.