View Single Post
Old 05-17-2011, 02:03 AM   #133
58mm of Bliss
PEI330Ci's Avatar
Join Date: Jul 2003
Location: PEI,Canada
Posts: 4,369
My Ride: 330i, 330Ci
Originally Posted by NickG@TechniqueTuning View Post
Yes, those are the ZHP cams. I'd get them if I were you.......oh wait, I already did
I should consult with you before hand so we can get our stories straight.

Originally Posted by zx5rider View Post
^^^ Anyways On another note. Going against what i was told

I was convinced that going with an 84.5mm bore was pretty much the only option I had.

1 Reason I was told is that the rings only come in .5mm increments and although the engine can't be bored anymore that 84.5 should be fine.

Worst thing that could happen is Re-sleeve.......

So I Ordered the 8.8:1 84.5mm CP Pistons

I'm going to hold off on the ATI Dampener and get a UUC Light weight flywheel+M5 Clutch and Greg's Oil Pump.

How does that sound?
One step at a time. Pistons are good.

Next step I would look at are bearings. What are you doing for those?
PEI330Ci is offline   Reply With Quote