View Single Post
Old 12-20-2011, 02:18 PM   #7
B7@ckBe@uty
Registered User
 
Join Date: Dec 2011
Location: Idaho
Posts: 20
My Ride: 03 325XI blk on blk
Quote:
Originally Posted by tasi333 View Post
I think I read that because of the chip that Dynavin uses, there is no "Bootloader" so no CWM or 4ext type interface will be available. The only way to flash is to load the ROM flash files to a SD card and boot.
From my understanding of computing and Android there has to be a bootloader. There is always a "BIOS" (in quotes cause they are called different things depending) its really just a matter of figuring out how to pause the boot process at the boot loader. With cells and tablets normally its holding down a couple of buttons at the same time during power up. Even your DVD player in your house or "smart" TV has a basic input output operating system. The Dynavin system may use a different method such as a signal pin on the rear going high or going low. If I had my hands on one I would run a check list of all of the different buttons and what two/ three button combos I could try and then run through them all. A new boot loader would give so much more functionality to the system.
B7@ckBe@uty is offline   Reply With Quote