Did any of you guys get this cable and software to work? I can get INPA to load and I have the battery/ignition solid circles. I was also able to connect to the engine DME and read/clear some errors.
But when I try to connect to the IHKA module, I get the error IFH-0009: No Response From Control Unit. When I try to connect to the instrument cluster module, I get the error: IFH-0006: Command Not Accepted.
When I run GT1/DIS, I get "Diagnosis bus error" "communication between operating unit and diagnostic head is impaired. Error number 200.159."
Last edited by forzam; 01-21-2012 at 11:13 PM.