View Single Post
Old 01-26-2012, 08:24 PM   #7
dmax
Registered User
 
dmax's Avatar
 
Join Date: Aug 2006
Location: NJ
Posts: 22,859
My Ride: '99 328i 1.04646 mu
Quote:
Originally Posted by chrislasser View Post
Pin was aligned in the notch. I drove the car pretty hard for 60 - 70 miles with no problem. The diagram of the belt was definitely routed right. Wasn't really able to see fan pulley, perhaps it was ate up a little bit?? Not sure, but i need to find a fan clutch tool. I have a 1 1/4 inch that will fit the 36mm nut, but don't have anything to hold those little bolts on water pump in place. Any suggestions?
Thanks a lot for the input.
I think it's a 32mm, but think the 1.25" is pretty close...but I don't want to do the math!

Guys hold a long screwdriver between the bolts on the wp to hold it. Also, if you're at all handy, look at the pictures of the tool and just get a piece of flat iron from HD...and make your own pulley holding tool...basically just a hole and a notch in the right place.
__________________


Performing at the Comedy Cove--595 Morris Ave. Springfield NJ reservations 973 376-3840

A recent set Skip to 1:30
dmax is offline   Reply With Quote