E46Fanatics - View Single Post - Stav's 330 N/A Progress Thread
View Single Post
Old 02-12-2012, 07:25 PM   #347
Registered User
Join Date: Dec 2008
Location: NJ>>>>FL
Posts: 3,025
My Ride: 04' 330ci/15' A3 TDI
Originally Posted by DarkJoker View Post
i know its not hard to replace its just the bearing torque and stuff that worries me
i have a mass of air tools to use of my own
Take something sharp and make a mark on the shaft and then on the nut () Obviously this is your reference point. Take the nut off, swap the input shaft and tighten the nut back on. It may take a couple tries to line them up, but you'll eventually get it.

Originally Posted by PEI330Ci View Post
Oh...and the "$300 here, $600 there" scenario will turn into "$3000 here, $6000 there". I've had an enourmous amount of labor put into my car. (Luckily the majority of it was done by myself) Also, I've spent over $5k on my tool set since I started my project. You've been warned...
secono330ci is offline   Reply With Quote