Thread: New SP Project
View Single Post
Old 04-11-2012, 04:23 PM   #115
Bdave
Registered User
 
Join Date: Feb 2008
Location: Fort Lauderdale
Posts: 1,827
My Ride: M3 HPF Stage 3
The custom fabricated 'Y" looks so nicely done. Why not use the many commercially available Y's in -10AN? They should flow just fine...and for a lot smaller cost. $33.99
http://www.jegs.com/i/Sniper-Motorsp...ductId=1712126

I am a big fan of the gold center wheels. Nice. But for really high HP applications I prefer 18 inch and even 17 inch for the rears. Are they 18's? What width is the rear tire? 295mm or 315mm? It looks huge. Its so hard fitting decent width rubber on non wide body E46's. Porsche and vette guys have it so much easier.

I see that big air filter. You simply have to run that size or larger to get good flow. But were you able to do it with out removing the AC compressor permanently?
__________________

Last edited by Bdave; 04-11-2012 at 04:27 PM.
Bdave is offline   Reply With Quote