I work at a shop and it cost me $500 in parts to fix the motor and yes I replaced the piston rings, all the bearings, replaced the one rod, had the crank sent out to be hot tanked and polished with the rotating assembly balanced, cylinder wall had no scoring so a light hone was done for fresh clean up. Dialed bore gauge was within specs and is round so only need to replace rings. Rings were gapped to OEM specs. Block was decked as well. Any other questions?
had all this done cause everyone was low balling the motor at $1000-$1250 and I know it will sell faster repaired for $2500.