View Single Post
Old 07-15-2012, 12:17 PM   #8
grubby_baker
Registered User
 
Join Date: Jul 2012
Location: Minnesota
Posts: 9
My Ride: 2005 325xi
well, removed the exhaust and was able to inspect the driveshaft. The u joints near the slip joint and carrier bearing are loose/sloppy. And the carrier bearing is now wore out. So, sent an email to Driveline Services of Portland for a quote. Broke the studs on the exaust manifold to pipe flange removing the exhaust. Any suggestions on that? Heat and hammer? Drill?
grubby_baker is offline   Reply With Quote