View Single Post
Old 08-19-2012, 06:30 PM   #1
Registered User
Join Date: Jun 2011
Location: Ireland
Posts: 215
My Ride: ESS TS2 325ci
Arrow Boost and Temp Gauge Install on ESS TS2

Hi Guys,
I am installing the defi racer gauges on my ESS TS2 tomorrow morning. I am hooking the boost gauge up to one of the two vacuum hoses on the intake manifold. I am connecting the oil temp gauge through the Ruff oil filter cap. I have 3 questions;

1. Does it matter which of the two vacuum hoses I connect the boost too as they are both not in use?EGR or Exhaust Flap Actuator?
2. It is a RHD car. Is the only entry from under the hood to the cabin of the car through the ECU box and is this the route I should take?
3. Last and most important question is. I am using the ATI gauge holder (the mickey mouse ears holder!). Is there any particular power supply wire behind this that you guys normally hook gauges up to or should I just borrow a voltmeter off a friend and go crazy?

Thanks in advance..
AndyN is offline   Reply With Quote
Ads by Google

Guests, get your FREE membership to remove this ad.