View Single Post
Old 09-27-2012, 02:22 PM   #3
nola mike
Registered User
 
Join Date: Jul 2011
Location: Richmond, VA
Posts: 56
My Ride: 2001 330 CiC
Quote:
Originally Posted by choxor View Post
No, it works when the circuit is opened. The rotor grinds through and breaks the loop. Was your brake indicator on before you changed the brakes. If not then the sensor should be fine. If so then you have to change it. Try turning the ignition to position 2 for 30 seconds to see if it resets.
No, the indicator wasn't on. The rotors needed changing, so I changed the pads as well. So it sounds like the light shouldn't trip unless the sensor is physically damaged, a wire is cut, or there's a bad connection? Again, disconnecting the sensor and checking for continuity should give me an answer, right? I'll try resetting the light as suggested...
nola mike is offline   Reply With Quote