View Single Post
Old 09-29-2012, 08:08 AM   #29
Dz1087
Registered User
 
Join Date: May 2012
Location: Nw fl
Posts: 59
My Ride: 2003 325Ci
Quote:
Originally Posted by jfoj View Post
If I were in your situation, the first thing I would do is check the reference Voltage at the crank sensor and see what you have there.

Then you need to figure out if there is a wiring connection problem or a hardware problem.
Gonna check the crank voltage today. If it too is showing 2.7, could that still be a wiring issue?


Now, upon further inspection, I found I have cracks in my upper boot and in one of the 'f' connector lines that run out of the upper boot.

I realize these can also cause the throttle delay, but with my dme previously throwing codes for the cam sensors, and now seeing they have less than the required voltage, I still suspect it a dme problem at the bottom of this issue. Thoughts?

Sent from my HTC_Amaze_4G using Bimmer App
Dz1087 is offline   Reply With Quote