View Single Post
Old 09-30-2012, 04:36 PM   #21
Bayerische E46
Registered User
 
Join Date: May 2012
Location: -
Posts: 130
My Ride: -
Quote:
Originally Posted by drift.mechanic View Post
Honestly there is no issue using an aluminum control arm. Problem would be the angle if the tip of the control arm (specifically the portion where the ball joint is).
I wouldn't risk it. If the aluminum control arm was cast that way, then fine, but to cut, weld, etc. No thanks.

Quote:
Originally Posted by IrocThe325i View Post
how do these change roll center?

http://store.bimmerworld.com/mobile/...StoreType=BtoC

Not from my iphone
^ Well, that's what I was thinking of - I guess it exists.

By the way, OP, is this going on a street car?
Bayerische E46 is offline   Reply With Quote