View Single Post
Old 09-30-2012, 05:25 PM   #30
IrocThe325i
Registered User
 
Join Date: Jan 2010
Location: NWNJ
Posts: 1,538
My Ride: chirps when I turn
Quote:
Originally Posted by mkodama View Post
I think it could be done.

Take a cylinder, machine a matching female conical seat, and a matching female thread to the control arm ball joint. Put wrench flats on the cylinder, and then you can tighten the "spacer" onto the ball joint. At the other end cylinder, give it an external thread and conical seat just like the ball joint. Mount everything like normal.

You would have a minimum length because the entire ball joint would need to fit within the spacer, but any ideas why that wouldn't work?
i had this idea before and someone told me the ball joints are pressed in from underneath?

Not from my iphone
__________________
@Jroel_drftsnk #driftsnake


Go Drifting Or Go To Hell
IrocThe325i is offline   Reply With Quote