View Single Post
Old 09-30-2012, 06:30 PM   #34
IrocThe325i
Registered User
 
Join Date: Jan 2010
Location: NWNJ
Posts: 1,549
My Ride: chirps when I turn
Quote:
Originally Posted by mkodama View Post
Not a very good option, but would work I think. You would have to remove the press fit ball joint from the control arm without damaging either item, press fit the space, ball joint, and control arm all back together without damaging anything again, and then you'd have to undo everything if you ever bend your control arm or need to replace a ball joint. A large washer isn't going to work to hold the spacer in because it won't be a tight enough fit, I don't think the bottom of the control arm is flat enough, and you decrease your clearance to the wheel barrel more.
this is a pita.

i just want to go lower and keep my factory suspension geometry!!! is this so much to ask!!!??

Not from my iphone
__________________
@Jroel_drftsnk #driftsnake

Go Drifting Or Go To Hell
IrocThe325i is offline   Reply With Quote