View Single Post
Old 10-01-2012, 04:32 PM   #124
///MPR77
Registered User
 
Join Date: Dec 2007
Location: Los Angeles
Posts: 1,852
My Ride: 02 ///M3 Tri-Ped
Reporting back with my VR VCG.
"at least 3k miles later"

Mine has not leaked again since i went back in there. I was expecting a warped VC, because this time i speak of was the third time opening it up to figure out why the reoccurring leak, which was specifically at the back passenger side corner of the VCG.

I described my method for tightening, and Dmax was kind enough to read my entire post, and had pointed out that i was tightening in an incorrect pattern.


Cliffs:

New Gasket leaked...Twice.

Third attempt reusing the second VR VCG, and Permatex® Ultra Black

Helpful insight from my only friend in Jersey.

Tightened all center studs first then alternate between, and out to the corners.

Perhaps I got lucky and got a good VR VCG, otherwise i would have had two different problems:

1. Bad tightening method
2. VR VCG from a "bad batch"

Just something to consider.
__________________

Bewahren Sie ihre ultimative fahrmaschine

Last edited by ///MPR77; 10-01-2012 at 04:35 PM.
///MPR77 is offline   Reply With Quote