View Single Post
Old 11-05-2012, 10:19 PM   #1
jessehell
Registered User
 
Join Date: Nov 2012
Location: WNY
Posts: 34
My Ride: 02 325i
Non continuous OBD monitors won't set

I've been trying to inspect my car for months in NY. I have read just about everything on google about e46 OBD readiness monitors and drive cycles and have tried it all. The 5 non continuous monitors will not change from "Not ready".
Here's the back story on what I have changed:
Tried for inspection first time(bought car a little over a year ago). We discover that my SES light doesn't illuminate, inspection shop turns a blind eye. Upon plugging car in, I have catalyst and evap as not ready(drove 10k miles prior). Automatic fail. I also have codes for evap very small leak and low fuel misfire.
I replace my fuel filter, gas cap, and find the vacuum line from filter to intake broke. Clear codes with Torque app. Drive a bit, secondary air system bank 1&2 codes come up.
I check secondary air system and find the vacuum line broke in two. Repair that, clear codes again.

Now I have no codes and all 5 non continuous monitors still read not ready. I have driven over 300 miles and specifically have spent over 100 of those doing drive cycles. I'm at a loss as to what to do next and hope someone has encountered this before??
jessehell is offline   Reply With Quote
Ads by Google

Guests, get your FREE E46Fanatics.com membership to remove this ad.