View Single Post
Old 11-06-2012, 09:45 AM   #19
TKC
Registered User
 
Join Date: Nov 2005
Location: San Jose, CA & Dallas, TX
Posts: 20,231
My Ride: 330cic & R6
Send a message via AIM to TKC
Quote:
Originally Posted by TrippinBimmer View Post
Did you install a AFR?

-Trip

Not yet... Suggestions?




Quote:
Originally Posted by InDiGlOM3 View Post
In my mind. If you blew your valve cover gasket.....something is wrong.

Sent from my PG86100 using Bimmer App
Plumbing is pretty straight forward so i don't think i did anything wrong. I'm hoping it's because I've never replaced the vcg on my car so it was old. It wasn't like seriously blown, but at the front, around the vanos area and above the front heat shield, i can see where the fresh oil leaked out after a drive. The only reason i knew was cause i smelled it burning when i turned on hvac while driving.
I got the parts to do vanos sealed while I'm at it, so the car should feel better after all that.
__________________
EUROPROJEKTZ - Director, NorCal Chapter
TKC is offline   Reply With Quote