View Single Post
Old 11-14-2012, 04:14 PM   #4298
zha50
Registered User
 
Join Date: May 2012
Location: S.E Melbourne, VIC
Posts: 175
My Ride: '04 325ci 5MT
Adjusted and aimed it last night. Still looks a little low could be higher for a 100% fit. The beam pattern is not affected by the should.



I might tackle them tonight again, bake them open and do some more cutting move the projector slightly higher so it sits 100%. It is actually sitting a little further back into the housing than the original projector. Don't think it would matter aesthetically too much once it is centered.

Noticed rotational alignment is still off by a few degrees between each projector, close but not perfect .... Still also need to look at the direction of the headlight not sure about the distance between the steps.


__________________


'04 325ci M-sport 5MT
- Bone stock -

Last edited by zha50; 11-14-2012 at 04:44 PM.
zha50 is offline   Reply With Quote