View Single Post
Old 11-15-2012, 02:59 PM   #55
taylor192
Registered User
 
Join Date: Feb 2012
Location: The Best Place on Earth
Posts: 1,763
My Ride: 2003.5 M3
There's no way you can drive it to a shop without a bushing, you'll ruin the RTA or RTA bushing enclosure, or both.

Just to confirm, when installing the RTAB you should have the MIS tool setup exactly like below, with the bushing on the side with the square block. Then pull the bushing into the RTA. It sounds like you're trying to pull the RTAB on an angle cause you don't have enough room to work. If you need more room to work disconnect the lower bolt on the shock.

That said, I agree with above that you've bitten off more than you can chew. Its time to let a professional tackle this to ensure its done properly.

taylor192 is offline   Reply With Quote