View Single Post
Old 11-26-2012, 08:56 PM   #4
///MPR77
Registered User
 
Join Date: Dec 2007
Location: Los Angeles
Posts: 1,852
My Ride: 02 ///M3 Tri-Ped
Quote:
Originally Posted by peytonracer4 View Post
Did you remove the end links at all? If so go back in and tighten them again. Even if they feel tight with your hand get your wrenches out and do it.
You'll need two wrenches. One to hold it while you tighten.
13mm I believe.
I'm guessing End Links as well.

17mm or 16mm depending on which brand you have.

OP, make sure to safely get both wheels off the ground before you tighten the end links...while you're there you may as well take them off, and inspect the ball joints on the end links (they should be pretty firm, a blown end link will be floppy), and will need to be replaced.

Good Luck.
__________________

Bewahren Sie ihre ultimative fahrmaschine
///MPR77 is offline   Reply With Quote