View Single Post
Old 11-30-2012, 05:10 PM   #93
Registered User
Join Date: Aug 2006
Location: Texas
Posts: 1,377
My Ride: Breaks too often
I used the same method everyone else is describing to install the bushings, but instead of using flat steel plates I used a pipe end cap from home depot, similar to the image below, and drilled a hole in the top center for a threaded steel rod to go through. I don't remember the exact size, but it was pretty much a perfect fit.


Last edited by JSanders; 11-30-2012 at 05:12 PM.
JSanders is offline   Reply With Quote