View Single Post
Old 12-04-2012, 03:07 AM   #18
TurnersInOz
Registered User
 
Join Date: Dec 2011
Location: Brisbane
Posts: 486
My Ride: 2004 325i
Quote:
Originally Posted by jlelectricllc View Post
I drained the system. Put coolant in until it came out of the bleed screw. Turned on heat high with fan on 1. engine off. The coolant will not go down. I put about 1.5 gallons in and it wont go down anymore. Any suggestions. Almost like the thermostat isnt kicking in. Its new tho
Is this the order you did it in? If so, things are a little off.
The heater should be on full hot (center console turned up as well) with the fan on the lowest setting with the ignition on, but engine not running.
Then you fill and bleed.

At this point you could run the engine until hot, and keep a close eye on the level in the ET.
TurnersInOz is offline   Reply With Quote