View Single Post
Old 12-22-2012, 11:38 PM   #8
ImSoFreaknWhite
Registered User
 
Join Date: Sep 2011
Location: San Diego, CA
Posts: 1,691
My Ride: '06 M3 SMG VERT
Send a message via ICQ to ImSoFreaknWhite Send a message via AIM to ImSoFreaknWhite Send a message via Yahoo to ImSoFreaknWhite Send a message via Skype™ to ImSoFreaknWhite
I just recently purchased 18x10 square set up for my m3. The front sticks out of the fender a bit too much, and the back looks fine with a 12mm spacer. I was wondering if any of you guys had any idea of a good amount of camber to run in the front to get the tire tucked under the fender as much as possible but without having to get new tires every 3,000 miles. I never track the car it would be strictly a street driving set up.

@Joe do you have any idea what that Tiag M3 has camber wise in the front? you mentioned he had a 18x10 square set up as well?
__________________
Jordan



My Build Thread

l Status Gruppe One-Piece Lip l Anodized CCW Classics w/ Polished Lips l Black Grills/Gills & Emblems l Carbon Fiber Roundels
Status Rear Section l K&N 57 Series CA Intake l OEM JB Hardtop l TM Drilled/Slotted Rotors l D2 Coilovers w/Camber Plates l VIS CSL VERT Trunk
ImSoFreaknWhite is offline   Reply With Quote