View Single Post
Old 01-02-2013, 05:16 PM   #552
Registered User
Join Date: Dec 2008
Location: NJ>>>>FL
Posts: 3,025
My Ride: 04' 330ci/15' A3 TDI
Originally Posted by rcsummers View Post
Stav, when you did the back seat, did you make the template using the bottom of the seat cushion, or just stuck some cardboard back there and traced the outline best you could.
I didn't use the seat cushion. I traced it out by measuring all the sides. It was a lot of trial and error, but after a few peices of plywood I got it right. If you want I can build one for you. If not, make sure you get at least a 1/4" thick plywood so it doesn't flop around while driving. Also, buy perforated plywood as it saves some weight. Again, this is all for the bottom part of the seat..for the top part that sits upright I reccomend a hard styrafoam insulation material. You can find all this at Home Depot. Hope that helps.

Lmk if you have anymore questions

Originally Posted by PEI330Ci View Post
Oh...and the "$300 here, $600 there" scenario will turn into "$3000 here, $6000 there". I've had an enourmous amount of labor put into my car. (Luckily the majority of it was done by myself) Also, I've spent over $5k on my tool set since I started my project. You've been warned...

Last edited by secono330ci; 01-02-2013 at 05:25 PM.
secono330ci is offline   Reply With Quote