Since I have apparently bled the system incorrectly should I drain the system from the drain in the ET and start over?
Dmax- I searched through mango's cooling guide for your post about your alternative bleeding method but couldn't find it. Poss I overlooked since there is over 800 posts.
I did notice the difference in the hot and cold level is different from the expansion of the coolant being hot.
Has anyone put a clear hose over the bleed screw hole or thread a barb with hose on it and pumped it back into the ET as to not waste a bunch of fluid on to the ground or into a drain pan? Just a thought I had.
Last edited by farkas330i; 01-06-2013 at 08:59 PM.