View Single Post
Old 01-07-2013, 01:51 AM   #23
Mango
New member? See my sig!
 
Mango's Avatar
 
Join Date: Mar 2006
Location: Southern California
Posts: 23,637
My Ride: M54B30
Quote:
Originally Posted by E46Snowball View Post
Bleed. I think it was impee that has a pretty good bleed method. Fill up with water till it comes out bleed screw with heat on. Put cap on and screw on bleeder screw but don't tighten all the way. Then start the car and Rev it a few times, not too hard though. Turn off and rebleed. After You bleed several times turn on the car with heat on full blast and wait till it gets to operating temp, if heat blows hot your good...if it doesn't rebleed...
Eh, no.
__________________
OVER A MILLION VIEWS
Mango is online now   Reply With Quote