|
Wiring directions are in Neil's thread... I haven't done reverse lights yet, but the directions are there also.
This is for the clutch switches. I had an issue with getting my wiring connector to click into the EWS. Once I fixed it, the car fired right up.
Clutch Switch:
Pin 1 - Goes to Ground (At Brake Light Switch)
Pin 2 - Goes to the DME connection at A60004 pin 23
Pin 3 - Goes to 12v+ (At Brake Light Switch)
It's connected in parallel to the Clutch Switch Module which is mounted on the side of the clutch master cylinder.
Clutch Switch Module:
Pin 1 - Goes to Ground (At Brake Light Switch)
Pin 2 - Goes to the DME connection at A60004 pin 23
Pin 3 - Goes to 12v+ (At Brake Light Switch)
Pin 4 - Goes to EWS Pinout #8
|