View Single Post
Old 01-18-2013, 10:57 AM   #20
Teddy7
Registered User
 
Join Date: Mar 2009
Location: Orlando, Florida
Posts: 936
My Ride: slides
Quote:
Originally Posted by cposk View Post
Wiring directions are in Neil's thread... I haven't done reverse lights yet, but the directions are there also.

This is for the clutch switches. I had an issue with getting my wiring connector to click into the EWS. Once I fixed it, the car fired right up.

Clutch Switch:

Pin 1 - Goes to Ground (At Brake Light Switch)
Pin 2 - Goes to the DME connection at A60004 pin 23
Pin 3 - Goes to 12v+ (At Brake Light Switch)

It's connected in parallel to the Clutch Switch Module which is mounted on the side of the clutch master cylinder.

Clutch Switch Module:

Pin 1 - Goes to Ground (At Brake Light Switch)
Pin 2 - Goes to the DME connection at A60004 pin 23
Pin 3 - Goes to 12v+ (At Brake Light Switch)
Pin 4 - Goes to EWS Pinout #8
^this is such great info, but I can tell this is where my swap is going to get annoying.
__________________
Teddy7 is offline   Reply With Quote