View Single Post
Old 01-22-2013, 06:38 AM   #14
325xittt
Registered User
 
Join Date: Apr 2010
Location: Reading, PA
Posts: 176
My Ride: 2003, 325 XIT
I'm guessing its the carrier number 8. The bearing 9 floats in a rubber membrane in the carrier housing. I'm guessing that has deteriorated. Dont forget item 11 a thick sticky gooey double sided tape that helps stabilize the carrier. Also the Bently manual say to pre-load the bearing by sliding it back (?) about 10 mm before tightening the mounting bolts all the way. You should consider replacing item 1 (guido) since it has to be removed to get to the bearing. Match mark your splines at both end before removing the axle. I used a oil filter strap wrench to loosen the item 5 locking collar
__________________
325xittt is offline   Reply With Quote