View Single Post
Old 02-07-2013, 09:55 PM   #6
pleiades
Registered User
 
Join Date: May 2012
Location: Oregon
Posts: 127
My Ride: M52TU
Quote:
Originally Posted by ///MPR77 View Post
You want it pretty tight.

Do what you can while its on the ground, and finish tightening after its all back togehter.

Once installed:

Use an Allen through the Socket, and a clamp on the socket, and vise grips on the Allen, and tighten.

GL.
+1. The nut should tighten properly once you have the strut assembly installed and the car on the ground.

If getting a 22 mm socket in there is the problem, Harbor Freight sells a 22 mm (7/8-inch) O2 sensor socket for a few bucks that you can sand down and fit in there quite well while counterholding with an allen key through the center.
pleiades is offline   Reply With Quote